How Long Can A Record Be?

LP record

A 12-inch LP vinyl record
Media type Audio playback
Capacity Originally 23 minutes per side, later increased by several minutes, much longer possible with very low signal level
Read mechanism Microgroove stylus (maximum tip radius 0.001 in or 25 μm)
Dimensions 12 in (30 cm), 10 in (25 cm), 90–240 g (3.2–8.5 oz)

Contents

How long should records be?

12 inch records are generally manufactured for full-length (LP) albums. At 33 rpm they hold around 15-22 minutes per side. 33 rpm is the most common speed for 12 inch records. Over 22 minutes per side is possible, but may require further adjustments to EQ and/or levels for it all to fit nicely and sound great.

How long is a long playing record?

n. (LP, abbr.) A sound recording on an analog disk measuring ten to twelve inches in diameter, with a playing time of more than five minutes at 33⅓ revolutions per minute.

How long is a 45 record?

7-inch
7-inch format
The 7-inch 45 rpm record was released 31 March 1949, by RCA Victor as a smaller, more durable and higher-fidelity replacement for the 78 rpm shellac discs.

How many songs can a vinyl record hold?

Why There Is No Set Amount Of Music A Vinyl Record Can Hold
Most will allow up to 25, with the disclaimer that the mastering engineer may need to do some extra equalization.

How long will a vinyl record last?

Your vinyl records can last anywhere from a year or two and up to well over 100 years. If you’re aiming for the latter, it really comes down to how well you care for your record collection.

How long is a 7 vinyl?

7″ Records (often referred to as 45’s) can be cut at 45 RPM or 33 1/3 RPM. When cut at 33 1/3 you can hold approximately 6:00 minutes per side. When cut at 45 you can hold approximately 4:30 minutes per side.

How long is a EP?

An EP is one to three songs, with one song at least 10 minutes long, and a total running time of 30 minutes or less. Or, four to six songs with a total duration of 30 minutes or less. Therefore, a release with one to three songs with none over 10 minutes is a single.

What defines an EP?

EP commonly stands for extended play, a musical recording which is popularly understood as shorter than a full album (about four to seven tracks).

How many times can a record be played?

A well-cared for record can be played more than 100 times, with only minor audible sound degradation. If carefully maintained the same disc could be played many hundreds of times in its lifetime. A record played on poorly set-up equipment can be destroyed in just one spin.

What records worth money?

40 vinyl records worth a fortune today

  • Led Zeppelin, Led Zeppelin (1969)
  • Miles Davis, Kind of Blue (1959)
  • The Who, The Who Sell Out (1967)
  • Nirvana, Bleach (1989)
  • XTC — Science Friction (1977)
  • David Bowie — The Prettiest Star (1973)
  • ABBA — Hova’s Vittne (1981)
  • The Quarrymen — That’ll Be the Day (1981)

What is a 7 record?

7 inch records (also called “45s”) are referred to by their playback speed of 45 rpm and their standard diameter of 7 inches. At 45 rpm they hold around 4-6 minutes per side. 45 rpm is the most common speed for 7 inch records.

How long is a single?

A single is considered 1-3 songs that are each less than 10 minutes in length. When releasing a single, don’t add “- Single” to your track or album titles.

Do vinyls only have one song?

The number of songs that a record can hold depends on the length of those songs. Records can definitely hold more than one song per record.Considering the fact that vinyl records are analog and not built like CDs. When put at 33 rpm, a record holds around 22 minutes of music on each side.

How much does it cost to press a vinyl record?

Rates usually depend on the length of the record per side. This can range from $150 – $230 per side ($300 – $460 per record) with the average being around $200 per side ($400 per record). We looked around at a few different pressing plants to get a ballpark figure of what a vinyl run costs.

Is it bad to let a record spin?

Never place or pick up a vinyl record as the turntable platter is spinning. This will quickly scratch the underside of a record. Always wait for the platter to come to a complete stop before doing anything with the record.

Does Vinyl break easily?

Vinyl records don’t break that easily, they generally don’t shatter, and they definitely don’t sound like glass when they break. This is a carryover from when those big round discs were shellac 78s, which do shatter dramatically (though they still don’t quite sound like glass).

Can you wear out a record?

There can be wear and tear on your records but under normal circumstances they won’t wear out to the point of not working for many hundreds or thousands of plays. The sound quality will go down after a few hundred plays but the record will still be able to be used.

How long is a 12-inch vinyl?

If you exceed the maximum time suggested for a record side, it can affect the quality of the audio.

SIZE SPEED OPTIMUM TIME
12″ 45 rpm 12 minutes
12″ 33 rpm 17 minutes
10″ 45 rpm 7 minutes
10″ 33 rpm 11 minutes

How much does it cost to press 100 records?

So, the average cost to press 100 12” vinyl records is $1225.
How Much Does the Record Pressing Process Cost?

Cost element Average cost Example cost for a pressing of 100 records
Jackets (stock black or white) $0.75 $75
Pressing set-up fee $190 $190
Test pressing (5) $65 $65
140g black vinyl record (per unit) $1.55 $155

How long is a 10 inch vinyl?

10″ Records (same size as classic 78’s) can be cut at 45 RPM or 33 1/3 RPM (we can cut them at 78 too, but few would be able to listen to them). When cut at 33 1/3 you can hold approximately 12:00 minutes per side. When cut at 45 you can hold approximately 9:00 minutes per side.