How To Change Watch Links?

Place the watch in the holder or on the foam with the arrows are facing downwards. Using the hammer, lightly tap the end of the push-pin tool over the cotter pins until you can no longer push the pin inside the link. When the pin pops through, remove it using your fingers or a small set of pliers.

Contents

Can you add watch links yourself?

Customizing your watch
You don’t have to take your watch to the jeweler. You can manage the links yourself, allowing you to customize your watch fit from your home. All you need is a good set of jeweler’s tools and a well-lit area. All your watches will fit exactly the way you need them to.

How do you take links out of a watch at home?

Method 1: By using a pin pusher

  1. Place the watch on the table with the push pins facing up.
  2. Insert the pin pusher into the hole and push the pin firmly.
  3. Once you’ve pushed the pin enough, it will pop out. Use pliers to remove it together with the link.
  4. Repeat the steps until you’ve removed the number of desired links.

Can you remove watch links at home?

Place the watch in the holder or on the foam with the arrows are facing downwards. Using the hammer, lightly tap the end of the push-pin tool over the cotter pins until you can no longer push the pin inside the link. When the pin pops through, remove it using your fingers or a small set of pliers.

How do I make my watch smaller?

Pinch the band evenly from the clasp until it is the proper size. Make sure you have an equal number of links on either side of the clasp that need to be removed. This will make sure the watch itself stays centered on the wrist band. Write down the number of links that need to be removed from either side of the clasp.

What can I use instead of a spring bar tool?

If you don’t have a spring bar tool available and you really need to change a tool you can use a very small knife or a small screwdriver.

Does Walmart remove watch links?

Yes! While Walmart will not remove watch links for you in-store anymore, it does sell watchmaker toolkits that will allow you to remove the links from your watch at home.You can purchase Walmart’s watch repair toolkits in-store and online, and you can buy kits from third parties on the Walmart website, too.

How do you remove a link?

To remove a hyperlink but keep the text, right-click the hyperlink and click Remove Hyperlink. To remove the hyperlink completely, select it and then press Delete.

Who takes links out of watches?

You can take your watch to any jeweler in your area that can remove links from watch to adjust to your wrist size. Even Macy*s will do it for free!

What size screwdriver do I need to remove links?

What Size Screwdriver you need to use to Remove Bracelet Links. As mentioned, the answer is that it depends on which watch you have. But many watch bracelets have screws for which you need a screwdriver with a size of 1.4-1.8mm. Worth adding is that the vast majority of watch bracelets use T-screws.

How should a watch fit?

Your watch wears too tight if it’s leaving imprints on your skin, and it’s too loose if you can fit several fingers under the band and it slides around on your wrist. Instead, your watch should be tight enough that it stays in place, with just a bit of room to move so that your wrist can breathe.

How much length does a watch Link add?

After obtaining the wrist diameter, add 1/2 to 1 1/2 inches to that measurement for an approximate watch band size. This additional length allows for how snug or how loose the wearer wants the band to fit.